Our Products

Other Security Equipment  

  • Bollards
  •  


Features & Specification :

Blocking Height

1000 MM

Blocking Dia

300 MM

Material

Bollard pipe is made of high quality steel i.e Steel FE360 with zinc based plastic quoting

Thickness of pipe: 15mm

Impact Rate Load

Certified to absorb- minimum kinetic energy of 610 KJ

Wheel Load

100kN according to SLW 60 - DIN 1072

Product Certification

Individual bollard carry crash rating M-30 (K-4) as per DOS (USA) or PAS 68 K4 (UK) /ASTM for impact load from 6.8 ton truck at speed of 30mile per hr.

Maximum level of vehicle Penetration

3 Feet from bollard after impact (for each bollard)

Operation Time: Normal use  

Raising: Approx 6 sec

Lowering to road surface: Approx 3 Sec

Operation time of bollards remain same from single unit to set of upto ten units. It does not increase in case of number of units is increased in a single set

Lighting

Bollards have red light reflector or indicator on top

Power Failure

Bollards remain in raised position in case of sudden power failure

Drive Unit

The drive unit is consisting of two hydraulic pumps with an integrated oil tank placed in the bollards framework. The hydraulic unit is a closed system without any external hydraulic tubes. The working principle of the hydraulic unit is to push the blocking element from the framework of the bollards via piston in the upper position. Manual release is possible via an access in the bollard head.

Pressure Limit Valve (Operating Pressure)

The pressure limit valve controls the operating pressure of the bollards

Hydraulic Unit

Compact hydraulic drive unit with aggregate, high pressure pump integrated in a drive cabinet. 

Control

Control Unit - Raise - Stop - Lower

Control Unit in drive cabinet,pre-wired in factory .

Protection against Corrosion

Long-term plastic against corrosion by zinc based multilayer plastic coating. The bollards have weatherproofing as per IP68 standard

Hydraulic Pressure Unit

Hydraulic Pressure Unit of the bollards is within the bollard
casing only,

Drive Cabinet

It is inside the bollard casing for each bollard.

Power

220V AC /24V DC

Maintenance Free

System is maintenance free till minimum 100000 duty
cycles(One opening and closing) 

Operating Temperature

Minimum. (-) 15°C Maximum (+) 55°C

Type

One master & slave units up to 9 for configuration for two, three or
up to ten bollards units

Electronic Control
Unit  

With micro processor & specific software for controlling bollards.

Control Cabinet

inside Security Control Room.

Mounting 

Control Cabinet is easily wall mountable.

Switch for Operation

Push Button

Features of control
unit  

(a)  Alarm 
(b)  Reversing Switch
(c)  Motor overload switch
(d)  Transformer 
(e) Strip Terminal
(f) Controller Fuse
(g) Running time monitor
(h) Main Switch 
(j)  Control Lifter 

Integration

Control box have ports to integrate with any kind of access
control reader for future use.         

Master Control Unit

Capable of controlling bollards set of maximum ten units,
There are slave control units to synchronize operation with one
master control unit. Bollards can be operated individually or in group through control board